H3C Technologies H3C S3100 Series Switches - Manual (Page 646)

2-11
Operation Command Description
Configure the port forward
delay of topology collection
requests
ntdp timer port-delay time
Optional
By default, the port forward
delay is 20 ms.
Configure the interval to collect
topology information
periodically
ntdp timer interval-in-minutes
Optional
By default, the topology
collection interval is one
minute.
Quit system view quit —
Launch topology information
collection manually
ntdp explore Optional
Enabling the cluster function
Follow these steps to enable the cluster function:
Operation Command Description
Enter system view system-view —
Enable the cluster function
globally
cluster enable
Required
By default, the cluster function
is enabled.
Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in manual mode or
automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Follow these steps to establish a cluster and configure cluster parameters in manual mode:
Operation Command Description
Enter system view system-view —
Specify the management
VLAN
management-vlan vlan-id
Required
By default, VLAN 1 is used as the
management VLAN.
Enter cluster view cluster —
Configure a IP address pool
for the cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required
Build a cluster build name
Required
name: cluster name.
Configure a multicast MAC
address for the cluster
cluster-mac H-H-H
Required
By default, the cluster multicast
MAC address is
0180-C200-000A.