H3C Technologies H3C S7500E Series Switches - Manual (Page 91)

4-22
Task Remarks
Configuring the OSPF Network Type for an Interface as
P2MP
Optional
Configuring the OSPF Network Type for an Interface as P2P Optional
Configuring OSPF Route Summarization Optional
Configuring OSPF Inbound Route Filtering Optional
Configuring ABR Type-3 LSA Filtering Optional
Configuring an OSPF Cost for an Interface Optional
Configuring the Maximum Number of OSPF Routes Optional
Configuring the Maximum Number of Load-balanced Routes Optional
Configuring a Priority for OSPF Optional
Configuring OSPF Route
Control
Configuring OSPF Route Redistribution Optional
Configuring OSPF Packet Timers Optional
Specifying an LSA Transmission Delay Optional
Specifying SPF Calculation Interval Optional
Specifying the LSA Minimum Repeat Arrival Interval Optional
Specifying the LSA Generation Interval Optional
Disabling Interfaces from Sending OSPF Packets Optional
Configuring Stub Routers Optional
Configuring OSPF Authentication Optional
Adding the Interface MTU into DD Packets Optional
Configuring the Maximum Number of External LSAs in LSDB Optional
Making External Route Selection Rules Defined in RFC 1583
Compatible
Optional
Logging Neighbor State Changes Optional
Configuring OSPF Network Management Optional
Enabling Message Logging Optional
Enabling the Advertisement and Reception of Opaque LSAs Optional
Configuring OSPF
Network Optimization
Configuring OSPF to Give Priority to Receiving and
Processing Hello Packets
Optional