Logging ipv6 peer/peer group state changes, Configuring a description for an ipv6 peer/peer, Group – H3C Technologies H3C S7500E Series Switches User Manual
Page 335: Disabling session establishment to an ipv6, Peer/peer group
11-6
In general, direct links should be available between eBGP peers. If not, you can use the peer
ebgp-max-hop command to establish a multi-hop TCP connection in between. However, you need
not use this command for direct eBGP connections with loopback interfaces.
Configuring a Description for an IPv6 Peer/Peer Group
Follow these steps to configure description for an IPv6 peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Configure a description for an IPv6
peer/peer group
peer { ipv6-group-name | ipv6-address }
description description-text
Optional
Not configured by default.
The peer group to be configured with a description must have been created.
Disabling Session Establishment to an IPv6 Peer/Peer Group
Follow these steps to disable session establishment to a peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Disable session establishment to an IPv6
peer/peer group
peer { ipv6-group-name |
ipv6-address } ignore
Optional
Not disabled by default
Logging IPv6 Peer/Peer Group State Changes
Follow these steps to configure to log on the session and event information of an IPv6 peer/peer
group: