H3C Technologies H3C S7500E Series Switches - Manual (Page 312)

9-17
To do… Use the command… Remarks
Display OSPFv3 area topology
information
display ospfv3 [ process-id ] topology [ area area-id ]
Display OSPFv3 virtual link
information
display ospfv3 [ process-id ] vlink
Display OSPFv3 next hop
information
display ospfv3 [ process-id ] next-hop
Display OSPFv3 link state request
list information
display ospfv3 [ process-id ] request-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ]
Display OSPFv3 link state
retransmission list information
display ospfv3 [ process-id ] retrans-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ]
Display OSPFv3 statistics display ospfv3 statistic
Display the GR status of the
specified OSPFv3 process
display ospfv3 [ process-id ] graceful-restart status
OSPFv3 Configuration Examples
Configuring OSPFv3 Areas
Network requirements
In the following figure, all switches run OSPFv3. The AS is split into three areas, in which, Switch B
and Switch C act as ABRs to forward routing information between areas.
It is required to configure Area 2 as a stub area to reduce LSAs in the area without affecting route
reachability.