H3C Technologies H3C S7500E Series Switches - Manual (Page 305)

9-10
If the cost value is not configured for an interface, OSPFv3 computes the interface cost value
automatically
Follow these steps to configure an OSPFv3 cost for an interface:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure an OSPFv3 cost
for the interface
ospfv3 cost value
[ instance instance-id ]
Optional
By default, OSPFv3 computes an interface’s
cost according to its bandwidth.
The cost value defaults to 1 for VLAN interfaces
and defaults to 0 for loopback interfaces.
Follow these steps to configure a bandwidth reference value:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPFv3 view ospfv3 [ process-id ] —
Configure a bandwidth reference
value
bandwidth-reference value
Optional
100 Mbps by default
Configuring the Maximum Number of OSPFv3 Load-balanced Routes
If multiple equal-cost routes to a destination are available, enabling load balancing among these routes
can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPFv3 view ospfv3 [ process-id ] —
Specify the maximum number of
load-balanced routes
maximum load-balancing
maximum
Optional
The value defaults to 8.