H3C Technologies H3C S7500E Series Switches - Manual (Page 290)

8-10
To do… Use the command… Remarks
Configure the maximum number of
equal cost RIPng routes for load
balancing
maximum load-balancing
number
Optional
The value defaults to 8.
Displaying and Maintaining RIPng
To do… Use the command… Remarks
Display configuration information
of a RIPng process
display ripng [ process-id ] Available in any view
Display routes in the RIPng
database
display ripng process-id
database
Available in any view
Display the routing information of a
specified RIPng process
display ripng process-id route Available in any view
Display RIPng interface
information
display ripng process-id
interface [ interface-type
interface-number ]
Available in any view
Reset a RIPng process reset ripng process-id process Available in user view
Clear statistics of a RIPng process reset ripng process-id statistics Available in user view
RIPng Configuration Example
Configure RIPng Basic Functions
Network requirements
As shown in Figure 8-4 , all switches run RIPng. Configure Switch B to filter the route (3::/64) learnt
from Switch C, which means the route will not be added to the routing table of Switch B, and Switch B
will not forward it to Switch A.
Figure 8-4 Network diagram for RIPng configuration
Configuration procedure
1) Configure the IPv6 address for each interface (omitted)
2) Configure basic RIPng functions