H3C Technologies H3C S7500E Series Switches - Manual (Page 306)

9-11
Configuring a Priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each protocol. When
these routing protocols find the same route, the route found by the protocol with the highest priority is
selected.
Follow these steps to configure a priority for OSPFv3:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPFv3 view ospfv3 [ process-id ] —
Configure a priority for
OSPFv3
preference [ ase ]
[ route-policy
route-policy-name ] preference
Optional
By default, the priority of OSPFv3
internal routes is 10, and priority of
OSPFv3 external routes is 150.
Configuring OSPFv3 Route Redistribution
Follow these steps to configure OSPFv3 route redistribution:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPFv3 view ospfv3 [ process-id ] —
Specify a default cost for
redistributed routes
default cost value
Optional
Defaults to 1
Redistribute routes from another
protocol, or another OSPFv3
process
import-route protocol [ process-id |
allow-ibgp ] [ cost value | route-policy
route-policy-name | type type ] *
Required
Not configured by
default
Inject a default route
default-route-advertise [ always | cost cost |
type type | route-policy route-policy-name ] *
Optional
Not injected by
default
Filter redistributed routes
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ isisv6 process-id |
ospfv3 process-id | ripng process-id | bgp4+ |
direct | static ]
Optional
Not configured by
default