H3C Technologies H3C S7500E Series Switches - Manual (Page 325)

10-2
Configuring IPv6 IS-IS Basic Functions
You can implement IPv6 inter-networking through configuring IPv6 IS-IS in IPv6 network environment.
Configuration Prerequisites
Before the configuration, accomplish the following tasks first:
z Enable IPv6 globally
z Configure IP addresses for interfaces, and make sure all neighboring nodes are reachable.
z Enable IS-IS
Configuration Procedure
Follow these steps to configure the basic functions of IPv6 IS-IS:
To do… Use command to… Remarks
Enter system view system-view ––
Enable an IS-IS process and enter
IS-IS view
isis [ process-id ]
Required
Not enabled by default
Configure the network entity title
for the IS-IS process
network-entity net
Required
Not configured by default
Enable IPv6 for the IS-IS process ipv6 enable
Required
Disabled by default
Return to system view quit ––
Enter interface view
interface interface-type
interface-number
––
Enable IPv6 for an IS-IS process
on the interface
isis ipv6 enable [ process-id ]
Required
Disabled by default
Configuring IPv6 IS-IS Routing Information Control
Configuration Prerequisites
You need to complete the IPv6 IS-IS basic function configuration before configuring this task.