H3C Technologies H3C S7500E Series Switches - Manual (Page 42)

3-7
To do… Use the command… Remarks
Enable the interface to receive RIP
messages
rip input
Optional
Enabled by default
Enable the interface to send RIP
messages
rip output
Optional
Enabled by default
Configuring a RIP version
You can configure a RIP version in RIP or interface view.
z If neither global nor interface RIP version is configured, the interface sends RIPv1 broadcasts and
can receive RIPv1 broadcast and unicast packets, and RIPv2 broadcast, multicast, and unicast
packets.
z If an interface has no RIP version configured, it uses the global RIP version; otherwise it uses the
RIP version configured on it.
z With RIPv1 configured, an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts
and RIPv1 unicasts.
z With RIPv2 configured, a multicast interface sends RIPv2 multicasts and can receive RIPv2
unicasts, broadcasts and multicasts.
z With RIPv2 configured, a broadcast interface sends RIPv2 broadcasts and can receive RIPv1
unicasts, and broadcasts, and RIPv2 broadcasts, multicasts and unicasts.
Follow these steps to configure a RIP version:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––
Specify a global RIP version version { 1 | 2 }
Optional
By default, if an interface has a
RIP version specified, the version
takes precedence over the global
one. If no RIP version is specified
for an interface, the interface can
send RIPv1 broadcasts, and
receive RIPv1 broadcasts,
unicasts, RIPv2 broadcasts,
multicasts and unicasts.
Return to system view quit —
Enter interface view
interface interface-type
interface-number
––