H3C Technologies H3C S7500E Series Switches - Manual (Page 48)

3-13
Follow these steps to configure RIP route redistribution:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––
Configure a default metric for
redistributed routes
default cost value
Optional
The default metric of a
redistributed route is 0 by default.
Redistribute routes from another
protocol
import-route protocol [ process-id
| all-processes | allow-ibgp ]
[ cost cost | route-policy
route-policy-name | tag tag ] *
Required
No redistribution is configured by
default.
Only active routes can be redistributed. You can use the display ip routing-table protocol command
to display route state information.
Configuring RIP Network Optimization
Complete the following tasks before configuring RIP network optimization:
z Configure network addresses for interfaces, and make neighboring nodes reachable to each
other;
z Configure RIP basic functions.
Configuring RIP Timers
You can change the RIP network convergence speed by adjusting RIP timers.
Follow these steps to configure RIP timers:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
––