H3C Technologies H3C S7500E Series Switches - Manual (Page 324)

10-1
10
IPv6 IS-IS Configuration
z The term “router” in this document refers to a router in a generic sense or a Layer 3 switch.
z EA cards (such as LSQ1GP12EA and LSQ1TGX1EA) do not support IPv6 features.
z IPv6 IS-IS supports all the features of IPv4 IS-IS except that it advertises IPv6 routing information
instead. This document describes only IPv6 IS-IS exclusive configuration tasks. For other
configuration tasks, see IS-IS Configuration in the Layer 3 - IP Routing Configuration Guide.
When configuring IPv6 IS-IS, go to these sections for information you are interested in:
z Introduction to IPv6 IS-IS
z Configuring IPv6 IS-IS Basic Functions
z Configuring IPv6 IS-IS Routing Information Control
z Displaying and Maintaining IPv6 IS-IS
z IPv6 IS-IS Configuration Example
Introduction to IPv6 IS-IS
The IS-IS routing protocol (Intermediate System-to-Intermediate System intra-domain routing
information exchange protocol) supports multiple network protocols, including IPv6. IS-IS with IPv6
support is called IPv6 IS-IS dynamic routing protocol. The international engineer task force (IETF)
defines two type-length-values (TLVs) and a new network layer protocol identifier (NLPID) to enable
IPv6 support for IS-IS.
TLV is a variable-length field in the link state PDU or link state packet (LSP). The two TLVs are:
z IPv6 Reachability: Defines the prefix, metric of routing information to indicate network reachability,
and has a type value of 236 (0xEC).
z IPv6 Interface Address: Same as the “IP Interface Address” TLV in IPv4 ISIS, except that the
32-bit IPv4 address is translated to the 128-bit IPv6 address.
The NLPID is an 8-bit field that identifies which network layer protocol is supported. For IPv6, the
NLPID is 142 (0x8E), which must be carried in hello packets sent by a router that supports IPv6 IS-IS.
For information about IS-IS, see IS-IS Configuration in the Layer 3 - IP Routing Configuration Guide.