H3C Technologies H3C S7500E Series Switches - Manual (Page 284)

8-4
z RFC 2081: RIPng Protocol Applicability Statement
Configuring RIPng Basic Functions
This section presents the information to configure the basic RIPng features.
You need to enable RIPng first before configuring other tasks, but it is not necessary for RIPng related
interface configurations, such as assigning an IPv6 address.
Configuration Prerequisites
Before the configuration, accomplish the following tasks first:
z Enable IPv6 packet forwarding.
z Configure an IP address for each interface, and make sure all nodes are reachable to one
another.
Configuration Procedure
Follow these steps to configure the basic RIPng functions:
To do… Use the command… Remarks
Enter system view system-view ––
Create a RIPng process and enter
RIPng view
ripng [ process-id ]
Required
Not created by default
Return to system view quit —
Enter interface view
interface interface-type
interface-number
––
Enable RIPng on the interface ripng process-id enable
Required
Disabled by default
If RIPng is not enabled on an interface, the interface will not send or receive any RIPng route.
Configuring RIPng Route Control
This section covers the following topics:
z Configuring RIPng Route Summarization
z Advertising a Default Route
z Configuring a RIPng Route Filtering Policy
z Configuring a Priority for RIPng