H3C Technologies H3C S7500E Series Switches - Manual (Page 55)

3-20
Displaying and Maintaining RIP
To do… Use the command… Remarks
Display RIP current status and
configuration information
display rip [ process-id |
vpn-instance
vpn-instance-name ]
Display all active routes in RIP
database
display rip process-id database
Display RIP interface information
display rip process-id interface
[ interface-type interface-number ]
Display routing information about a
specified RIP process
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ]
Available in any view
Reset a RIP process reset rip process-id process
Clear the statistics of a RIP
process
reset rip process-id statistics
Available in user view
RIP Configuration Examples
Configuring RIP Version
Network requirements
As shown in Figure 3-4 , enable RIPv2 on all interfaces on Switch A and Switch B.
Figure 3-4 Network diagram for RIP version configuration
Configuration procedure
1) Configure an IP address for each interface (Omitted)
2) Configure basic RIP functions
# Configure Switch A.
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0
# Configure Switch B.
[SwitchB] rip