H3C Technologies H3C S7500E Series Switches - Manual (Page 353)

11-24
To do… Use the command… Remarks
Clear IPv6 BGP route flap information
reset bgp ipv6 flap-info
[ ipv6-address/prefix-length | as-path-acl
as-path-acl-number | regexp as-path-regexp ]
IPv6 BGP Configuration Examples
Some examples for IPv6 BGP configuration are similar to those of BGP4, so see BGP Configuration in
the Layer 3 - IP Routing Configuration Guide for related information.
IPv6 BGP Basic Configuration
Network requirements
In the following figure are all IPv6 BGP switches. Between Switch A and Switch B is an eBGP
connection. Switch B, Switch C and Switch D are fully meshed through iBGP connections.
Figure 11-1 IPv6 BGP basic configuration network diagram
Configuration procedure
1) Configure IPv6 addresses for interfaces (omitted)
2) Configure iBGP connections
# Configure Switch B.
system-view
[SwitchB] ipv6
[SwitchB] bgp 65009
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] ipv6-family
[SwitchB-bgp-af-ipv6] peer 9:1::2 as-number 65009
[SwitchB-bgp-af-ipv6] peer 9:3::2 as-number 65009
[SwitchB-bgp-af-ipv6] quit