H3C Technologies H3C S7500E Series Switches - Manual (Page 163)

5-18
Task Remarks
ID to Host Name
Mappings
Configuring Dynamic System ID to Host Name Mapping Optional
Configuring IS-IS GR Optional
Enabling the Logging of Neighbor State Changes Optional
Enabling IS-IS SNMP Trap Optional
Binding an IS-IS Process with MIBs Optional
Configuring BFD for IS-IS Optional
Configuring IS-IS Basic Functions
Configuration Prerequisites
Before the configuration, accomplish the following tasks:
z Configure the link layer protocol.
z Configure an IP address for each interface, and make sure all neighboring nodes are reachable to
each other at the network layer.
Enabling IS-IS
Follow these steps to enable IS-IS:
To do… Use the command… Remarks
Enter system view system-view ––
Enable the IS-IS routing process
and enter its view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
Required
Not enabled by default
Assign a network entity title (NET) network-entity net
Required
Not assigned by default
Return to system view quit ––
Enter interface view
interface interface-type
interface-number
––
Enable an IS-IS process on the
interface
isis enable [ process-id ]
Required
Disabled by default
Configuring the IS Level and Circuit Level
If only one area is available, it is recommended that: