H3C Technologies H3C S7500E Series Switches - Manual (Page 332)

11-3
Task Remarks
Configuring IPv6 BGP Soft Reset Optional
Enabling the BGP ORF Capability Optional
BGP Networks
Configuring the Maximum Number of
Load-Balanced Routes
Optional
Configuring IPv6 BGP Peer Group Optional
Configuring IPv6 BGP Community Optional
Configuring a Large Scale
IPv6 BGP Network
Configuring an IPv6 BGP Route Reflector Optional
Configuring IPv6 BGP Basic Functions
Prerequisites
Before configuring this task, you need to:
z Specify IP addresses for interfaces.
z Enable IPv6.
You need create a peer group before configuring basic functions for it. For related information, see
Configuring IPv6 BGP Peer Group .
Specifying an IPv6 BGP Peer
Follow these steps to configure an IPv6 BGP peer:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Specify a router ID router-id router-id
Optional
Required if no IP addresses are
configured for any interfaces.
Enter IPv6 address family view ipv6-family —
Specify an IPv6 peer
peer ipv6-address as-number
as-number
Required