H3C Technologies H3C S7500E Series Switches - Manual (Page 350)

11-21
To do… Use the command… Remarks
Apply a routing policy to routes
advertised to an IPv6 peer/peer
group
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Required
Not applied by default.
z When configuring IPv6 BGP community, you need to configure a routing policy to define the
community attribute, and apply the routing policy to route advertisement.
z For routing policy configuration, see Routing Policy Configuration in the Layer 3 - IP Routing
Configuration Guide.
Configuring an IPv6 BGP Route Reflector
Follow these steps to configure an IPv6 BGP route reflector:
To do… Use the command… Remarks
Enter system view system-view —
Enter BGP view bgp as-number —
Enter IPv6 address family view ipv6-family —
Configure the router as a route
reflector and specify an IPv6
peer/peer group as a client
peer { ipv6-group-name |
ipv6-address } reflect-client
Required
Not configured by default.
Enable route reflection between
clients
reflect between-clients
Optional
Enabled by default.
Configure the cluster ID of the
route reflector
reflector cluster-id cluster-id
Optional
By default, a route reflector uses
its router ID as the cluster ID