H3C Technologies H3C S7500E Series Switches - Manual (Page 371)

12-14
# On Switch B, apply the route policy when redistributing routes.
[SwitchB] ospf
[SwitchB-ospf-1] import-route isis 1 route-policy isis2ospf
[SwitchB-ospf-1] quit
# Display the OSPF routing table on Switch A. The cost of route 172.17.1.0/24 is 100, the tag of route
172.17.1.0/24 is 20.
[SwitchA] display ospf routing
OSPF Process 1 with Router ID 192.168.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
192.168.1.0/24 1 Transit 192.168.1.1 192.168.1.1 0.0.0.0
Routing for ASEs
Destination Cost Type Tag NextHop AdvRouter
172.17.1.0/24 100 Type2 1 192.168.1.2 192.168.2.2
172.17.2.0/24 1 Type2 20 192.168.1.2 192.168.2.2
172.17.3.0/24 1 Type2 1 192.168.1.2 192.168.2.2
192.168.2.0/24 1 Type2 1 192.168.1.2 192.168.2.2
Total Nets: 5
Intra Area: 1 Inter Area: 0 ASE: 4 NSSA: 0
Applying a Route Policy to IPv6 Route Redistribution
Network requirements
As shown in the following figure:
z Enable RIPng on Switch A and Switch B.
z On Switch A, configure three static routes, and apply a route policy to static route redistribution to
permit routes 20::0/32 and 40::0/32, and deny route 30::0/32.
z Display RIPng routing table information on Switch B to verify the configuration.
Figure 12-2 Network diagram for route policy application to route redistribution
Configuration procedure
1) Configure Switch A.
# Configure IPv6 addresses for VLAN-interface 100 and VLAN-interface 200.
system-view
[SwitchA] ipv6