Verilink Access Manager 2000 (896-502037-001) Product Manual User Manual
Page 62

Installing Access Manager
2-12
Access Manager 2000 User Manual
For detailed information on the installation or operation of
pcANYWHERE, refer to the manual supplied with it. Additional default
setting information regarding use with Access Manager is given in this
section.
To install pcANYWHERE in a host PC:
1. Install pcANYWHERE onto the host PC hard disk into the same
directory where Access Manager was installed. Typically, this
directory is named
AM2000
.
2. Copy pcANYWHERE files from the program diskettes into that
directory, as explained in the pcANYWHERE user’s manual.
The following pcANYWHERE III parameters settings should be used
when configuring the host PC:
pcANYWHERE
Parameter
Setting
Baud rate
The baud rate setting depends on the modem type in use.
This setting can range from 50 to 57600 baud, or it can be set
to Auto-baud. Access Manager works at 1200 and 9600 bau
with a modem or, if direct connect, up to 19200 baud.
The DEC VT100 default setting is 300 baud.
Com Port
Alway COM
Connect type
There are 3 connection options:
Direct Connect
,
Automatic Modem
, or
Manual Modem
, with the
following limitations.
• For
Direct Connect
, do not use any “log in”; that is,
set the log in parameters to
Defaults
. Also set the
inactivity time-out to
0
.
• For a
Manual Modem
connection, use “log in”.
Co-pilot mode
Either system keyboard may be made active. The normal
setting should be
Both Keyboards Active
.