Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 181)

Configuring circuit elements
Access Manager 2000 User Manual 5 -57
• Figure 5 -7, “Configuration: 551VST List 2 Menu,” on pag e5-45
• Figure 5 -8, “Configuration: 551VST-ML List 2 Menu,” on
page 5-46
• Figure 5 -9, “Configuration: AS2000 Menu,” on page 5 -46
4. Select the List option.
When the parent node is a 551VST ML List 1 or List 2 and Access
Manager has configured none of its CSU circuit elements, then the first
time you access these circuit elements, they are all shown with 4016 List
2 options, because the true type of CSUs are not yet known.
For example, consider a 4016 List 1 CSU installed in a 551VST ML shelf
and accessed through the Data Link. When you configure the circuit
element the first time, the option menu for a 4016 List 2 is displayed.
After you press to confirm the configuration with the
Installed and Operational and Enable Remote
Configuration options as YES , a connection is made to the far-end
node and the 4016 List 1 identification is retrieved through the Data Link.
When the CSU returns a 4016 List 1 identification, it is configured as a
4016 List 1 and not a 4016 List 2. Since the CSU identification is now
stored in the database, any future access to this circuit element’s
configuration displays the correct 4016 List 1 options menu.
CAUTION
For all installations equipped with 551VST ML List 1 or List 2 and
4016 List 1 or List 2, firmware upgrades must be performed to the
NMC List 1 or List 2 Controller and the 4016 List 1 CSUs before
attempting to remotely configure either of the following.
■
551VST ML List 1 or List 2 (with NMC List 1 Controller with
revision 2.3 or earlier firmware) with near-end 4016 List 2. For
operation with Access Manage , the NMC List 1 Controller must be
upgraded to firmware revision 3.0 or later. If 4016 List 1 CSUs are
provided, they must also be upgraded to firmware revision 2.4 or
later.
Configuration
Menus of 4016 List
1 and List 2 CSUs
F5
!