Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 219)

Configuration Options for AS2000 and ConnecT1 Plus
Access Manager 2000 User Manual 5 -95
channels may be entered by using a hyphen between the first and
last channel.
Certain DIU 2130 and DIU 1130 applications require unrestricted ZEROs
density operation. Remember the following:
■
If the data rate is a multiple of 56 kbps and you configure the DIU
for the 56 kbps user data/channel mode, the DIU data ports are in
the unrestricted ZEROs density operating mode.
■
If the data rate is a multiple of 64 kbps and you configure the DIU
for the 64 kbps user data/channel mode, review the configuration of
the CSU used with the DIU 2130 and DIU 1130. You have
unrestricted ZEROs operation if the configuration of the CSU is
(1)
NET Density Enforcement = NONE , and (2) Enable
NET B8ZS = YES .
■
If the data rate is a multiple of 64 kbps and you configure the DIU
for the 64 kbps user data/channel mode, you have unrestricted zeros
operation if your
Channel Assignments are not contiguous
and none of the channels are adjacent. Alternate channel
assignments satisfy this criterion.
EQP Name
Type the name of the equipment (EQP) connected to I/O Port 1 of the
DIU. This name can have up to 25 characters, including spaces. After
entering this name, press the right-arrow key and do the same for the
equipment on I/O Port 2.
EQP SER
Type the serial number (or other identification) of the equipment (EQP)
associated with the port. Move to the next column, and enter the serial
number of this port’s equipment. Each entry can be up to 25 characters.
This parameter is informational only.
EQP Interface
Enter the type of interface (V.35, RS449, or RS530) of each data port.
This parameter is informational only.