Verilink Access Manager 2000 (896-502037-001) Product Manual User Manual
Page 201
Configuration Options for AS2000 and ConnecT1 Plus
Access Manager 2000 User Manual
5
-77
If you set the
Retrieve Far-End Data
option to
YES
, you must
also set the
Retrieve Near-End Data
option to
YES
, and there
must be a circuit built between the near-end and far-end circuit elements.
Do not set
Retrieve Far-End Data
to
YES
at both the near-end
and far-end circuit elements. For example, set
Retrieve Far-End
Data
to
YES
for the near-end NCC, CCC, or TAC and set
Retrieve
Far-End Data
to
NO
for far-end circuit element. The defaults for
these options is
NO
, except near-end
Net Use
, which is
YES
.
This option must be set to
YES
and the
Installed and
Operational
option must also be set to
YES
to enable Access
Manager to configure the selected CSU circuit elements.
The options following
Save Configuration to CSU
are
downloaded to the CSU circuit element when
is pressed. If this
option is set to
NO
, any changes made are saved in the database but are
not downloaded to the CSU circuit element.
CSUs can report alarm conditions to Access Manager when excessive
errors occur or the line service is degraded.
If you don’t want the CSU to report alarm conditions to Access Manager,
your choice is simple. Set the
Enable Alarm Reporting
field to
NO
.
To allow the CSU to report alarm conditions to Access Manager:
1. Set
Enable Alarm Reporting
to
YES
.
2. Make sure that in the Node Configuration screen of the parent node,
you have:
•
set the
Enable Alarm Reporting
to
YES
•
downloaded the alarm path for that node
Otherwise, the CSU will send alarms to the node controller, but the
node controller will not forward these alarms to Access Manager.
Save
Configuration to
CSU
F5
Enable Alarm
Reporting