Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 54)

Installing Access Manager
2-4 Access Manager 2000 User Manual
Software Installation
This section provides instructions for installing Access Manager 2000
software on your host PC’s hard disk.
The Access Manager software is provided on two diskette sets:
■
a 3.5-inch (720 kilobyte density) diskette set, and
■
a 5.25-inch (1.2 Mb density) diskette set
Both diskette sets have identical content. The INSTALL.EXE program
file is on Diskette # 1 of either disk set. Use the one which fits your floppy
drive.
When you install Access Manager 2000, the following files are copied to
your hard disk.
Table 2-1 Access Manager Installation Files
ACTIVE.KEY ALARMLOG.DAT ALARMLOG.KEY ALRMDESC.DAT
ALRMDESC.KEY AM2000.EXE AM2000.OVL AM2000.SIG
BUS.KEY CETABLE.DAT CETABLE.KEY CFROM.KEY
CIRCUIT.KEY CNFSTAT.DAT CNFSTAT.KEY COLORATT.DAT
COMLINE.DAT COMLINE.KEY CONFIG.SYS CTO.KEY
DATALOG.DAT DATALOG.KEY DBVERS.DAT DTEVLOG.DAT
DTEVLOG.KEY EQUIPMNT.DAT EQUIPMNT.KEY LEVEL.DAT
LEVEL.KEY LOCATION.KEY MONOATT.DAT NETVLOG.DAT
NETVLOG.KEY NODE.DAT NODE.KEY NODEID.KEY
POINT.DAT POINT.KEY PORT.DAT PORT.KEY
PRENNAME.KEY RANDC.DAT RANGE.DAT RANGE.KEY
README.DOC RFROM.KEY ROUTE.KEY RTO.KEY
SCNAME.KEY SDDNAME.KEY SDNAME.KEY SELECTED.DAT
SELECTED.KEY SIGCSU.DAT SIGDDSU.DAT SIGDSU.DAT
SITE.DAT SITE.KEY SSUPARM.DAT SSUPARM.KEY
TYPE.KEY UNCLRALM.DAT UNCLRALM.KEY USER.DAT
USER.KEY USERLOG.DAT USERLOG.KEY VERINET.DBD