Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 103)

Configuring the site
Access Manager 2000 User Manual 4-17
Adding a new comline definition
1. From the Installation Menu select Comline .
2. From the Revise Comline Definitions screen, select Add .
3. The Add Comline Definition screen appears, showing the default
value for each item listed.
• If no other Comlines were previously defined, COM1 appears as
the Comline name in this screen.
• If other Comlines were previously defined, the screen shows the
next highest available Comline (COM2 through COM16, as
appropriate).
CAUTION
If Access Manager 2000 is accessed remotely by Accumaster or a
remote terminal, COM1 is the remote access port. It must be
configured in the host PC setup of pcANYWHERE III. It is not
configured in the database. Therefore, when using Access Manager
in a remote access mode, assign COM2 and successive comline
from Access Manager as described in the following paragraphs, and
delete COM1 from the database.
Note: The Comlines must be added in consecutive numeric order. If a
Comline name greater than COM16 is used, the message
COMLINE NAME MUST BE COMx (where x is 1 to 16) appears.
!