Verilink Access Manager 2000 (896-502037-001) Product Manual - Manual (Page 138)

Configuring the T1 Network
5-14 Access Manager 2000 User Manual
The following desired node definition values can now be entered.
Node Name This uniquely identifies each node. This identifier is
always unique and cannot be duplicated for use with other
nodes. It can have up to 16 characters, including spaces or
dashes.
Node ID This identification number can only be in the range from
1 to 65,535. Every time you add a new node, the node ID
that appears is the next higher available number. You may
keep that number or change it, but two nodes cannot share
the same Node ID.
Location This identifies the node site---usually the location of a
customer’s equipment. This field can be up to 30
characters long. It is used to display nodes in alphabetical
order, by location. Multiple nodes can have the same
location.
Equipment type The default type is a 551 VST List 2 CSU.
A list of the available options can be accessed by pressing .
The available equipment types are as follows:
System Shelf Type(s) With an AS2000 or
ConnecT1 shelf, you must specify the type of shelf or
shelves you’re using. You must follow certain rules of
syntax when entering this information. This information
can be found in “Specifying shelf types for AS2000
nodes” on page 5 -15.
Previous Node in chain You can access up to three
AS2000 or ConnecT1 Plus nodes through a single node
connection. This access arrangement is called a daisy
chain.
Identifying the
node
F8
Use this option for a 551VST List 2
with ASCII interface firmware.