Hypertherm Phoenix 8.0 - Manual (Page 87)

Setups
80
Pierce Complete
The Automatic Pierce monitors the voltage of sensors in the laser head and compares
them to the value set by this parameter to detect the completion of the pierce.
Next Pulse
Based on sensors in the laser head, the system can determine when the next Laser Pulse is
delivered during Automatic Pierce control. The voltage is derived from the feedback of
the sensors in the laser cutting head.
Cut Chart
A cut chart database allows the user to select factory recommended settings or amend the
database for personalized settings. The Cut Chart information can be saved or loaded via
the hard drive, floppy drive or USB memory stick. The Cut Chart files contain the
factory recommended settings that are available from Hypertherm.
Notes:
•
Refer to the FAST Laser operator’s manual for complete information on the operation
and setup of the FAST Laser head.
•
The FAST Laser Laser parameters must first be enabled in the password protected
Station Configuration screen to allow use of the Cut Chart Information
•
Specific Material, Process Power, Assist Gases, Material Thickness, Focal Length
and Nozzle data fields allow new values to be added. Double click on the field to
enter an new value or press the Plus key “+” to add or “-“ to delete on the keypad.