Hypertherm Phoenix 8.0 - Manual (Page 566)

Edge Ti
559
Motor Power Pinout
Pin# Description
1
Brushless Motor-A or Brush +
2 Brushless Motor-B or Brush -
3 Brushless Motor-C
4 Brake + (24VDC, 250ma max)
5 Brake -
6 Cable Shield
7 No Connect
Additional Notes:
1. Brake output is limited to 250ma total. This output is only used on the THC vertical
axis.
Drive Motor Mating Connector
Connector AMP #211399-1
Backshell AMP #206966-1
Sockets 16-18AWG AMP #66101-3
Cabling: Use Belden # 9552 or equivalent for brushed motor signals
Cabling: Use Belden # 9553 or equivalent for brushless motor signals
Encoder Pinout:
1 Encoder
+5V
2 Encoder GND
3 Encoder Channel A
4 Encoder Channel A/
5 Encoder Channel B
6 Encoder Channel B/
7 Encoder Channel Z
8 Encoder Channel Z/
9 +V Hall Out (6V @ 30MA max)
10 Hall GND
11 Hall - A
12 Hall - B
13 Hall - C
14 Cable Shield
Additional Notes:
1. Only 5 Volt encoders are supported.
2. Hall Sensors are used with Brushless motors only.
3. Inside the Edge Ti, dipswitches are used to select Brush or Brushless mode, 2
switches per axis. Can mix Brushed and Brushless if switches are set properly.