Hypertherm Phoenix 8.0 - Manual (Page 234)

Library Shapes
227
Left Width
Enter the width of the left side of the part.
Center Width
Enter the width of the center of the part.
Right Width
Enter the width of the right side of the part.
Top Height
Enter the height of the top of the part.
Center Height
Enter the height of the central portion of the part.
Bottom Height
Enter the height of the bottom portion of the part
Hole Diameter
Enter the length of the diameter of the hole within the part.
Inside Corner Radius
Enter the length of the radius of the curve on the inside of the corner.
Lead In Radius
Enter the radius of the lead-in arc.
Lead Out Radius
Enter the radius of the lead-out arc.