Hypertherm Phoenix 8.0 - Manual (Page 470)

Program Codes
463
3B 3B 3B 3B 3B
Advanced Feature Codes
17B
Kerf Table
CODE DESCRIPTION
G59 D1-200Xvalue Sets kerf table variable from 1-200
G41 D1-200
Enables Left Kerf using a Kerf Table variable
G42 D1-200 Enables Right Kerf using a Kerf Table variable
G43 D1-200 Changes current kerf value via Kerf Table using previously set Left or
Right kerf
18B
Tilt / Rotator Part Codes
73B 73B 73B 73B
CODE DESCRIPTION
G00 Avalue Sets Tilt angle as a preparatory command – A is the angle value in
degrees
G00 XYvalue Avalue Performs Linear Interpolation of Tilt angle along line segment.
G00 Avalue Fvalue Sets Tilt angle – Angle value in degrees with a speed command in RPM
M28
Disables Follower
M29 Enables Follower
M90 Preparatory Cmd - Aligns Rotator to Tangent angle of next cut segment
M90- Align rotator when not using shortest path motion
M75 A axis/Tilt Goto Home Cmd - Rapid Index
G00 Cxx Move to rotate “C” position
G01 Cxx Fxx Move to rotate “C” position with Speed “F” command
G00 C180- Rotate Axis align 180 degrees will continue to rotate in the proper
direction
G00 C-180- Rotate Axis align -180 degrees will continue to rotate in the proper
direction
G01 C180- Fxx Rotate Axis align 180 degrees with speed
G01 C-180- Fxx Rotate Axis align -180 degrees with speed
19B
Automatic Torch Spacing Program Codes
74B 74B 74B 74B
CODE DESCRIPTION
M32 Unclamp / Unlock All Stations
M33 Unclamp / Lock All Stations
M34 Clamp / Unlock All Stations
M34Tvalue Clamp / Unlock ‘T” Station, where T = 1 through 19
M35 Clamp / Unlock All Stations Mirror
M35Tvalue Clamp / Unlock Mirror “T” Station, where T = 1 through 19
M77 Go to Home position Y Axis
M78 Go to Home position X Axis