Hypertherm Phoenix 8.0 - Manual (Page 496)

Automated Plasma Interface
489
Load Cut Charts
Press the load Cut Charts soft key to load the factory default database files which are supplied by
Hypertherm in a text file (.txt), user files (.usr) or factory files (.fac) from a diskette or USB memory
stick.
Factory text file names.
Mild Steel Cut Chart Data mschart.txt
Aluminum Cut Chart Data alchart.txt
Stainless Steel Cut Chart Data sschart.txt
The database should be updated through the control rather than the Power Supply if the serial
communications link is enabled.
Test Preflow
Pressing the Test Preflow soft key performs the Test Preflow Gases feature at the Plasma supply.
Test Cutflow
Pressing the Test Cutflow soft key performs the Test Cutflow Gases feature at the Plasma supply.
Notes:
• Refer to the power supply operator’s manual for complete information on the operation and setup of
the plasma supply.
• A serial communications port for the plasma supply must first be selected at the Port configuration
screen to enable the feature for use.
• The plasma supply parameters must first be enabled in the password protected Station Configuration
screen to allow the cut chart information for the plasma supply to be available.
• Power Supplies equipped with the integrated Command THC may be used with the control setups.
The Command THC must first be enabled for use in the password protected Station Configuration
Screen.