Hypertherm Phoenix 8.0 - Manual (Page 390)

Password Setups
383
Support for Command THC
Selecting a Command THC as the lifter for a process enables the serial link to be
assigned for a single Command THC.
Note: The actual serial port must be assigned on the Ports setup screen. This also
configures the selected Plasma or Marker Cut Types screen to display the Command
THC features. If a Command THC has been selected for a station but does not use the
serial communication to the control, the lifter type should be set to Other.
Refer to the Command THC section for additional information on the operation of the
Command THC.
Support for HD4070
The HD4070 feature establishes the Serial Link HD4070 Power Supply communication
link and configures the selected Plasma or Marker Cut Types screen to display the
HD4070 features. A single HD4070 must be assigned to Stations 1 and 2. A second,
multi-dropped HD4070 can be assigned on stations 3 and 4.
Each HD4070 can use two integrated Command THCs. These are controlled by the
HD4070 and have designated station locations.