Station configuration – Hypertherm Phoenix 8.0 User Manual
Page 385
Password Setups
378
Station Configuration
This password protected screen for the Voyager III and Mariner controls is used to
configure a plasma, marker or laser torch station for use. This provides a single location
to assign the tool, process, and lifter selections for the station. You can configure up to
eight stations for the plasma 1 & 2 and marker 1 & 2 process selections.
The “4532” password allows you to view the Station configuration screen and verify
setups but does not allow changes.
You can also use this station configuration screen to enable the serial link for the
Command THC, as well as serial communication for the HD4070 and HPR130 plasma
systems.
You can use codes within a part program to select the stations that are used. These
station codes enable a THC station and are used in conjunction with the process selection
codes to configure the cut or mark process.
When a station selection code is executed through program codes, the corresponding
station select output is active.