Hypertherm Phoenix 8.0 - Manual (Page 284)

Part Options
277
Manual Part Alignment
To align a part manually on the plate:
1. Set parameters that are needed to align your part in the upper right corner of the
screen.
2. Move the torch to the first corner location (Corner to Align with) using the jog keys.
3. Press At Corner.
4. If you are aligning a part, go to step 7.
5. Move the torch to a point along the edge of the plate toward the selected Skew
Reference.
6. Press At Skew Point.
7. Press OK. The machine will move to the start point for the part and return to the
Main screen and be ready for cutting.
Corner to Align with
Selects the corner of the plate to align the part in.
Scrap Clearance
This is the amount of clearance between the edge of the plate and the part the control will
add in when moving to the start point of the part.