Hypertherm Phoenix 8.0 - Manual (Page 240)

Library Shapes
233
Left End Width
Enter the distance between the left side and the center of the left pipe.
Distance Between Pipes
Enter the distance between the center of the pipes.
Right End Width
Enter the distance between the right side and the center of the right pipe.
Height
Enter the height of the part.
Pipe Radius
Enter the radius (measured vertically) of the pipes.
Number of Pipes
Enter the number of pipes in the part.
Lead-In/Lead-Out Length
Enter the appropriate value to ensure proper piercing (lead-in) and gas bleed-off (lead-
out) to obtain optimum cut quality.
The location for the lead-in and lead-out is fixed, but can be changed by using the
ShapeWizard and then saving the new shape to disk.
Part Type
Indicate whether you want to cut the part as a separate piece or a hole in a larger part.
Chain cut options are available for simple shapes that have external cut paths.