Automatic nesting setup – Hypertherm Phoenix 8.0 User Manual
Page 117
Shape Manager
110
Automatic Nesting Setup
Pressing the Setup soft key accesses the following setup parameters and can be used to
configure the automatic nesting process for use. Note: If this feature is not available
(grayed out), the feature has not been enabled on your CNC. Contact your CNC vendor
for details on how to enable the Automatic Nesting feature.
Automatic Nesting
Switching the Nesting Parameter to Automatic enables the feature for use.
Part Spacing
The Part Spacing feature sets the spacing between parts during the Automatic Nesting
process.
Plate Edge Spacing
This parameter allows the user to set spacing around the edge of the plate to be used
during the Automatic Nesting process.
Program Origin
The Program Origin (nest start location) may be set to lower left, upper left, bottom left
or bottom right.