Hypertherm Phoenix 8.0 - Manual (Page 577)

Voyager III
570
Mating Connector
8C Phoenix Connector – Phoenix Part # 1803633
Divider PCB - 5C Connector J3 to Plasma Supply / Table
Pin Number Description
1 Ground ( Chassis Ground )
2 Electrode ( Plasma DC – )
3 Work ( Plasma DC + )
4 NC
5
Shield ( Nozzle Contact )
SERCOS to Analog Conversion Card
`
Decimal Read Out
The 7 segment display indicates SERCOS ring phases status 1-4. Additionally, the 2
decimal points in the 7 segment display indicate phase condition for the SERCOS ring
and are on immediately after CNC boot up and reset. They remain on until the ring is
successfully phased up to phase 4. After that the decimal points remain off even if the
ring drops from phase 4. With this approach, if the SERCOS ring is not running, you can
determine if the ring has ever made it to phase 4 during that power on cycle. This
assumes the card has not been reset or lost power.
Decimal Read
RX Fiber
I/O
indicator
Drive Address
Dip Switches
Power Connector
Status Indicator
Lights
Axis Enable
Programming
Port
TX Fiber