Machine interface – Hypertherm Phoenix 8.0 User Manual
Page 544
MicroEdge
537
THC, Joystick & Speedpots
Optional features for two Sensor THC, one Joystick and two Speedpots are offered.
Note: Use of some monitors and other devices may require loading of a device driver for
operation. Many standard device drivers are located in the C:\CABS or C:\CABS\I386
folders.
Machine Interface
The MicroEDGE shape cutting control is an extremely versatile product offering up to
four configurable axes of motion, configurable I/O locations and a convenient table
interface for ease of installation. The control features may also be expanded through use
of optional analog and network interface cards.
The rear panel of the control has several cable connectors to connect the control to power,
I/O and communication ports. These connectors are clearly labeled as to their function.
AC Input
The AC power cable is inserted into the AC power connector and plugged into a standard
3-way 110 or 220 volt outlet. The control has a universal AC input power module that
allows the user to plug into either voltage without changing additional jumpers. In
addition, the AC Power connector contains an integral fuse receptacle and line filter.