Hypertherm Phoenix 8.0 - Manual (Page 48)

Setups
41
normal or single for correct translation. The selection should be set to Normal unless
your part programs require two decimal shift to the right of the decimal point.
M17, M18 Used as Cut Codes
This allows the EIA-274D M17 and M18 codes to be used for cut on and off commands
when enabled.
M76 Rotary Shortest Path
When enabled, this disables tilt and rotate software overtravels for dual tilt-style bevellers
and allows the EIA-274D M76 Rotate go to Home command to select shortest path.
When disabled it allows motion by longest path when homing. This is advantageous for
some bevel head designs.
Stop on Single Arc Lost
If this setting is enabled, any cut sense input that is lost for longer than the arc off time
during the cut pauses the part program or nest with a Cut Sense Lost message.
Show Traverse Segments
Allows traverse segment lines (displayed in yellow) to be turned OFF or ON during all
part preview displays.
Retain Skew Adjustment
Retains the last calculated plate skew for all subsequent parts that are loaded. If disabled,
any new part that is loaded will remove any previously calculated plate skew.
THC Voltage Offset
The THC Voltage Offset parameter is used to offset the individual Sensor THC arc
voltages from the master set arc voltage. This allows the individual THCs to be adjusted
to compensate for consumable wear and obtain optimum cut quality.