Comtech EF Data DMD20 - Manual (Page 84)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–74
Command Data (3 Bytes)
<1> Rx RS N Code 2 – 255 Reed-Solomon code word length
<1> Rx RS K Code 1 – 254 Reed-Solomon message length
<1> Rx RS Depth 4, 8 or 12 Reed Solomon Interleaver Depth
Opcode: <2A34h>
Command Demodulator TPC Interleaver
Command Data (1 Byte)
<1> TPC Interleaver 0 = Disabled, 1 = Enabled
Opcode: <2A35h>
Command Demodulator Async Configuration
Command Data (4 Bytes)
<1> ES Mode 0 = Normal, 1 = Enhanced
<1> ES Type 0 = RS-232, 1 = RS-485
<1> ES Baud 0 =150, 1 = 300, 2 = 600, 3 = 1200, 4 = 2400, 5= 4800,
6 = 9600, 7 = 19200, 8 = 38400, 9 = 57600, 10 =
115200
<1> ES Data Bits 0 = 7 Bits, 1 = 8 Bits
Opcode: <2A36h>
Command a Demodulator's Fast Acquisition
Command Data (1 Byte)
<1> Fast Acquisition 0 = Disabled, 1 = Enabled
Opcode: <2A37h>
Command Clear Demodulator Ethernet Terrestrial Interface Packet Status
(No Parameters)
Command Data (0 Bytes)
Opcode: <2A38h>
Command a Demodulator's RFM AGC Time Constant
Command Data (2 Bytes)
<2> RFM AGC Time
Constant 1 - 99999 in ms
Opcode: <2A39h>
Command a Demodulator's CNC Setup
Command Data (6 Bytes)
<1> Carrier-in-Carrier 0 = Disabled, 1 = Enabled
<2> Carrier-in-Carrier
Minimum Search
Delay
0 – 330
<2> Carrier-in-Carrier
Maximum Search
Delay
0 – 330
<1> Carrier-in-Carrier
Frequency Offset
Range
0 – 30 (KHz)
1.5.3
Modem Queries & Commands: