Comtech EF Data DMD20 - Manual (Page 109)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol SNMP (MIB)
MN-DMDREMOTEOP Revision 9 2–13
::= { radDmd20ModNVStatus 33 }
radDmd20TxAupcRemoteTestPattern OBJECT-TYPE
SYNTAX ControlType
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Disables/Enables the remote site test pattern. This applies only if AUPC
option is enabled."
::= { radDmd20ModNVStatus 34 }
radDmd20TxAupcTargetEbnoDbX100 OBJECT-TYPE
SYNTAX INTEGER (400..2000)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the AUPC EbNo. There is an implied decimal point. This applies
only if the AUPC option is enabled."
::= { radDmd20ModNVStatus 35 }
radDmd20TxAupcMinCarrierLeveldBmX100 OBJECT-TYPE
SYNTAX RadAupcTransmitPowerLevel
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the AUPC minimum power limit. There is an implied decimal point.
This applies only if AUPC option is enabled."
::= { radDmd20ModNVStatus 36 }
radDmd20TxAupcMaxCarrierLeveldBmX100 OBJECT-TYPE
SYNTAX RadAupcTransmitPowerLevel
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the AUPC maximum power limit. There is an implied decimal point.
This applies only if AUPC option is enabled."
::= { radDmd20ModNVStatus 37 }
radDmd20TxAupcNomCarrierLeveldBmX100 OBJECT-TYPE
SYNTAX RadAupcTransmitPowerLevel
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the AUPC nominal power level. There is an implied decimal point.
The nominal level must be between the minimum and the
maximum power limits. This applies only if AUPC option is enabled."
::= { radDmd20ModNVStatus 38 }
radDmd20TxTestPattern OBJECT-TYPE
SYNTAX INTEGER {
normal(1),
test2047(2),
testPattern2To15Minus1(3),
testPattern2To23Minus1(4)
}
MAX-ACCESS read-write