Comtech EF Data DMD20 - Manual (Page 143)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol SNMP (MIB)
MN-DMDREMOTEOP Revision 9 2–47
radDmd20RxAgcVoltage OBJECT-TYPE
SYNTAX INTEGER (0..990)
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Rx Agc Voltage Level in Volts. There is an implied decimal point.
A value of 450 corresponds to 4.50V"
::= { radDmd20DemodStatus 35 }
-- ----------------------------------------------------------------------------------------------------
-- Dmd20 common non-volatile status information.
radDmd20CommonExternalExcClock OBJECT-TYPE
SYNTAX INTEGER (2400..20000000)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the external clock frequency, being provided on the Ext BNC port"
::= { radDmd20CommonNVStatus 1 }
radDmd20CommonExternalReference OBJECT-TYPE
SYNTAX INTEGER (256000..10000000)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the external frequency reference in Hz. Valid settings are
from 256 KHz to 10 Mhz in 8 kHz steps."
::= { radDmd20CommonNVStatus 2 }
radDmd20CommonFrequencyReferenceSource OBJECT-TYPE
SYNTAX INTEGER {
internal(1),
external(2),
highStab(3)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the frequency reference source."
::= { radDmd20CommonNVStatus 3 }
radDmd20CommonAlarms1Mask OBJECT-TYPE
SYNTAX BITS {
minus12VoltAlarm(0),
plus12VoltAlarm(1),
plus5VoltAlarm(2),
bit3Reserved(3),
bit4Reserved(4),
bit5Reserved(5),
ifLoSynthesizerFault(6),
bit7Reserved(7)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION