Comtech EF Data DMD20 User Manual
Page 108
DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol
SNMP (MIB)
MN-DMDREMOTEOP Revision 9
2–12
radDmd20TxAupcLocalCarrierLossAction OBJECT-TYPE
SYNTAX INTEGER {
hold(1),
nominal(2),
maximum(3)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects what action to take at the local site if the carrier is lost while
using AUPC. This applies only if AUPC option is enabled."
::= { radDmd20ModNVStatus 30 }
radDmd20TxAupcRemoteCarrierLossAction OBJECT-TYPE
SYNTAX INTEGER {
hold(1),
nominal(2),
maximum(3)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects what action to take at the remote site if the carrier is lost while
using AUPC. This applies only if AUPC option is enabled."
::= { radDmd20ModNVStatus 31 }
radDmd20TxAupcTrackingRate OBJECT-TYPE
SYNTAX INTEGER {
zeroPointFivedbPerMin(1),
onedbPerMin(2),
onePointFivedbPerMin(3),
twodbPerMin(4),
twoPointFivedbPerMin(5),
threeonedbPerMin(6),
threePointFivedbPerMin(7),
fourbPerMin(8),
fourPointFivedbPerMin(9),
fivedbPerMin(10),
fivePointFivedbPerMin(11),
sixdbPerMin(12)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the AUPC tracking rate in dB/min. This applies only if AUPC option
is enabled."
::= { radDmd20ModNVStatus 32 }
radDmd20TxAupcRemoteBasebandLoopback OBJECT-TYPE
SYNTAX ControlType
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Disables/Enables the remote site baseband loopback. This applies only if AUPC
option is enabled."