Comtech EF Data DMD20 User Manual
Page 114
DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol
SNMP (MIB)
MN-DMDREMOTEOP Revision 9
2–18
DESCRIPTION
"Selects the baud rate for enhanced async. This applies only if the async
mode is set to enhanced."
::= { radDmd20ModNVStatus 54 }
radDmd20TxEsBitsPerChar OBJECT-TYPE
SYNTAX INTEGER {
seven(1),
eight(2)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the data bits setting for enhanced async. This applies only if the async
mode is set to enhanced."
::= { radDmd20ModNVStatus 55 }
radDmd20TxCarrierDelaySec OBJECT-TYPE
SYNTAX INTEGER (0..255)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"LBST systems- selects the minimum number of seconds the modulator waits between
power-up and enabling the carrier for the first time. This allows time for
the BUC to stabilize.
Non-LBST systems- set to zero."
::= { radDmd20ModNVStatus 56 }
radDmd20TxSccCtlRatio OBJECT-TYPE
SYNTAX INTEGER {
ratio1(1),
ratio2(2),
ratio3(3),
ratio4(4),
ratio5(5),
ratio6(6),
ratio7(7)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects SCC format overhead ratio."
::= { radDmd20ModNVStatus 57 }
radDmd20TxSccInbandRate OBJECT-TYPE
SYNTAX Unsigned32 (300..115200)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the SCC format in-band overhead rate."
::= { radDmd20ModNVStatus 58 }
radDmd20TxSctClockPolarity OBJECT-TYPE
SYNTAX INTEGER {
normal(1),
inverted(2)