Comtech EF Data DMD20 - Manual (Page 101)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol SNMP (MIB)
MN-DMDREMOTEOP Revision 9 2–5
::= { radDmd20ModNVStatus 1 }
radDmd20TxNetworkSpec OBJECT-TYPE
SYNTAX INTEGER {
closedNet(1),
idr(2),
ibs(3),
dropInsert(4),
dvbSat(5),
milStd188pt165A(6),
rfm(7)
}
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the modulator's mode of operation. The mode sets a
number of parameters within the modulator to meet a set of
specifications. The purpose is to eliminate additional
commands and compatibility problems."
::= { radDmd20ModNVStatus 2 }
radDmd20TxCarrierLeveldBmX100 OBJECT-TYPE
SYNTAX RadTransmitPowerLevel
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the Tx power level in dBm. There is an implied decimal point.
For example, a value of -100 represents a transmit power level
of -10.0 dBm."
::= { radDmd20ModNVStatus 3 }
radDmd20TxCarrierFrequencyHz OBJECT-TYPE
SYNTAX Unsigned32 (50000000..180000000|950000000..2050000000)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects IF frequency in Hz steps. The range is 50 MHz to 180 MHz
for the 70/140 MHz modems and 950 MHz to 2050 MHz for the LBand
modems. It is based on whatever options are installed."
::= { radDmd20ModNVStatus 4 }
radDmd20TxTerrDataRateHz OBJECT-TYPE
SYNTAX Unsigned32 (4800..52000000)
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Selects the data rate in BPS. The data rate minimum is 4800 bps.
It varies based on modulation and code rate.
Please refer to the Dmd product specifications manual
for maximum Data Rate Limits."
::= { radDmd20ModNVStatus 5 }
radDmd20TxStrapCode OBJECT-TYPE
SYNTAX INTEGER (0..1000)
MAX-ACCESS read-write
STATUS current