Comtech EF Data DMD20 - Manual (Page 52)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–42
Command Data (1 Byte)
<1> AUPC Remote BB
Loopback 0 = Disabled, 1 = Enabled
Opcode: <262Fh>
Command AUPC Remote Test 2047
Command Data (1 Byte)
<1> AUPC Remote 2047 0 = Disabled, 1 = Enabled
Opcode: <2630h>
Command AUPC Eb/No
Command Data (2 Bytes)
<2> AUPC Target Eb/No Target Eb/No at Receiver, 400 to 2000 (4.00 db to
20.00 db)
Opcode: <2631h>
Command AUPC Minimum Power
Command Data (2 Bytes)
<2> AUPC Minimum
Power
For DMD20 Signed value 0 to –2500 with implied
decimal point; (0.00 to –25.00 dBm) (two’s compliment)
For OM20 Signed value -2000 to -4500 with implied
decimal point; (-20.00 to -45.00 dBm)
Opcode: <2632h>
Command AUPC Maximum Power
Command Data (2 Bytes)
<2> AUPC Maximum
Power
For DMD20 Signed value 0 to –2500 with implied
decimal point; (0.00 to –25.00 dBm) (two’s compliment)
For OM20 Signed value -2000 to -4500 with implied
decimal point; (-20.00 to -45.00 dBm)
Opcode: <2633h>
Command AUPC Nominal Power
Command Data (2 Bytes)
<2> AUPC Nominal
Power
For DMD20 Signed value 0 to –2500 with implied
decimal point; (0.00 to –25.00 dBm) (two’s compliment)
For OM20 Signed value -2000 to -4500 with implied
decimal point; (-20.00 to -45.00 dBm)
Opcode: <2634h>
Command AUPC Local Configuration
Command Data (12 Bytes)
<1> AUPC Local Enable 0 = Off, 1 = EF AUPC, 2 = Radyne AUPC
<1> AUPC Local CL
Action
0 = Hold, 1 = Nominal, 2 = Maximum
<1> AUPC Tracking Rate 0 = 0.5 dB/Min, 1 = 1.0 dB/Min, 2 = 1.5 dB/Min, 3 = 2.0
dB/Min, 4 = 2.5 dB/Min, 5 = 3.0 dB/Min, 6 = 3.5 dB/Min,
7 = 4.0 dB/Min, 8 = 4.5 dB/Min, 9 = 5.0 dB/Min, 10 =
5.5 dB/Min, 11 = 6.0 dB/min
<1> AUPC Remote CL
Action 0 = Hold, 1 = Nominal, 2 = Maximum
<2> AUPC Target Eb/No Target Eb/No at Receiver, 400 to 2000 (4.00 db to
20.00 db)