Comtech EF Data DMD20 - Manual (Page 67)

DMD20/DMD50/DMD2050/DMD2050E/DMD1050/OM20 Remote Protocol Remote Operations
MN-DMDREMOTEOP Revision 9 1–57
<2> RFM AGC Time
Constant 1 - 99999 in ms
<1> Carrier-in-Carrier 0 = Disabled, 1 = Enabled
<2> Carrier-in-Carrier
Minimum Search
Delay
0 – 330
<2> Carrier-in-Carrier
Maximum Search
Delay
0 – 330
<1> Carrier-in-Carrier
Frequency Offset
Range
0 – 30 (KHz)
<1> EBEM overhead
channel rate
0 = Off, 1 = 8K, 2 = 16K, 3 = 24K, 4 = 32K, 5 = 40K, 6
= 48K, 7 = 56K, 8 = 64K
<1> EBEM embedded
channel
0 = Off, 1 = On
<1> EBEM ITA 0 = Disabled, 1 = Enabled
<1> EBEM encryption 0 = Disabled, 1 = Enabled
<4> EBEM Ethernet rate 4800 to 52000000
Opcode: <240Ch>
Query a Demodulator's Status
Query Response (88 Bytes)
<1> Control Mode 0 = Front Panel, 1 = Terminal, 2 = Computer, Note:
DMD20 will always return 2 = Computer
<1> Revision Number Decimal point implied
<1> Alarm 1 Bit 0 = Receive FPGA/Processor Fault, 1 = Fail
Bit 1 = Carrier Loss, 1 = Fail
Bit 2 = Multiframe Sync Loss, 1 = Fail
Bit 3 = Frame Sync Loss, 1 = Fail
Bit 4 = IBS BER Alarm, 1 = Fail
Bit 5 = Satellite AIS, 1 = Fail
Bit 6 = Rx Data Activity, 1 = Activity
Bit 7 = Rx AGC Level, 1 = Fail
<1> Alarm 2 Bit 0 = Buffer Underflow, 1 = Underflow
Bit 1 = Buffer Overflow, 1 = Overflow
Bit 2 = Buffer Under 10%, 1 = Fail
Bit 3 = Buffer Over 90%, 1 = Fail
Bit 4 = RS Decoder Lock Fault, 1 = Fail
Bit 5 = RS De-Interleaver Fault, 1 = Fail
Bit 6 = RS Decoder Uncorrectable Word, 1 = Fail
Bit 7 = Demod Summary Fault, 1 = Fail
<1> Alarm 3 Bit 0 = Rx L-Band Synthesizer Lock, 1 = Lock
Bit 1 = Insert DSP Config, 1 = Fail
Bit 2 = Buffer Clock PLL Lock Detect, 1 = Lock
Bit 3 = Viterbi Decoder Lock, 1 = Lock
Bit 4 = Sequential Decoder Lock, 1 = Lock
Bit 5 = Rx Test Pattern Lock, 1 = Lock
Bit 6 = External Reference PLL Lock, 1 = Lock
Bit 7 = Rx Carrier Level, 1 = Fail