Benutzen des suchers, Hinweis, Benutzen des lcd-monitors – Panasonic NVDS33EG User Manual
Page 25: Schließen des lcd-monitors, Using the finder, Note, Using the lcd monitor, Closing the lcd monitor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

-►
12:30:45
15.10.1999
DEUTSCH
Benutzen des Suchers
Vor dem Benutzen des Suchers diesen präzis so auf
die Sehkraft Ihrer Augen abstimmen, daß die Anzeigen
im Sucher kiar und deutlich sichtbar sind.
1
Den Schalter [POWER] auf [CAMERA] oder
[VCR] stellen.
Beim Schieben auf [CAMERA] oder [VCR] den
Knopf im Schalter gedrückt halten.
Den Sucher bis zum Anschlag nach hinten
schieben und ihn dann nach oben schwenken.
Zum Herausziehen des Suchers diesen nie an der
Augenmuschel ziehen.
Der Sucher kann bis zu einem Winkel von maximal
75° hochgeschwenkt werden.
Den Okularkorrektur-Regler O nach links
oder rechts drehen, bis die Anzeigen im
Sucher klar und deutlich sind.
Hinweis;
Darauf achten, daß der Sucher nicht direkter
Sonnenbestrahlung ausgesetzt wird. Die
Vergrößerungslinse wirkt wie ein Brennglas und kann
den Sucher beschädigen.
Benutzen des LCD-Monitors
Sie können auch aufnehmen, während Sie das Motiv
auf dem geöffneten LCD-Monitor betrachten.
H
Den Schalter [POWER] auf [CAMERA] oder
[VCR] stellen.
Beim Schieben auf [CAMERA] oder [VCR] den
Knopf im Schalter gedrückt halten.
Die Taste [PUSH OPEN] drücken und den LCD-
Monitor in Pfeilrichtung um ca. 90° öffnen.
Der Sucher schaltet automatisch ab.
Den Winkel des LCD-Monitors dem
gewünschten Aufnahmewinkel
entsprechend einstellen.
• Der LCD-Monitor läßt sich aus seiner normalen
senkrechten Stellung um maximal 180° nach
oben und vorne @ und 90° nach unten o
drehen. Ein gewaltsames Drehen über diesen
Bereich hinaus könnte den Camerarecorder
ernsthaft beschädigen.
Schließen des LCD-Monitors
Den LCD-Monitor gegen das Camerarecorder-
Gehäuse schwenken, bis die Taste [PUSH OPEN] mit
einem Klick einrastet.
ENGLISH
Using the Finder
Before using the Finder, adjust it to your eyesight so
that the indications in the Finder are clear and easy to
read.
1
Set the [POWER] Switch to [CAMERA] or
[VCR].
While pressing the centre button, slide the switch
to [CAMERA] or [VCR].
Slide the Finder backward completely and
then tilt it upward.
Do not pull on the Eyecup to extend the Finder.
The Finder can be tilted upward by up to
approximately 75°.
Adjust by turning the Eyepiece Corrector
Lever O-
Note:
Do not leave the Finder exposed to direct sunlight, as
its magnifying glass could bundle the light beams and
seriously heat-damage the Finder.
Using the LCD Monitor
You can also record while viewing the picture on the
opened LCD Monitor.
1
]
Set the [POWER] Switch to [CAMERA] or
[VCR].
While pressing the centre button, slide the switch
to [CAMERA] or [VCR].
Press the [PUSH OPEN] Button and turn
out the LCD Monitor by approximately 90°
in the direction of the arrow.
The Finder turns off.
Adjust the angle of the LCD Monitor
according to the recording angle.
•The LCD Monitor rotates upward a maximum of
180° 0 and downward by a maximum of 90° 0
from its normal vertical position. Trying to
forcefully rotate it beyond this range could
seriously damage the Movie Camera.
Closing the LCD Monitor
Push the LCD Monitor close until the [PUSH OPEN]
Button locks with a click.
-26-