Analog update mode – KEYENCE LS-7000 User Manual
Page 98
4-46
Chapter 4 Function Settings
4
Setting Method
1
Press the
ENT
key when the output
setting is displayed.
2
Press the
FUNC
key four times.
3
Press the
or
key and set the +10 V value.
PROG No.
AREA
DISP
ESC
G
C
ENT
HOLD
ZERO
FOCUS
A
POSITION
HI
GO
LO
Press these keys to
set the value.
The selectable
part flashes.
Indicates +10 V
value.
Press this key to a
positive or negative
one.
4
Press the
ENT
key.
The input item is entered and the value in the next line flashes.
5
Press the
or
key and set the -10 V value.
6
Press the
ENT
key.
The input item is entered and the output setting display appears again.
Note:
If the input conditions are not satisfied, “Error-4” will appear on the main
display. Reset the error status by pressing the
ENT
key or
ESC
key and make
the settings again.
■ Analog update mode
If the analog update mode is ON, the measured value after area calculation will be
output after analog scaling.
HI
GO
LO
1
Press the
ENT
key when the output
setting is displayed.
2
Press the
FUNC
key five times.
HI
GO
LO