Dell POWEREDGE M1000E - Manual (Page 726)

724 Configuring IP Multicast
RP Set Summary
Use the PIM-SM RP Set Summary page to display the static RP information for the PIM-SM router.
To display the page, click Multicast > PIM-SM > RP Set Summary in the tree view.
Figure 12-51. PIM-SM RP Set Summary
The PIM-SM RP Set Summary page displays the following fields in a table:
• Group Address — Displays IP multicast group address.
• Group Mask — Displays Multicast group address mask.
•
Address — Displays IP address of the Candidate-RP.
• Hold Time (hh:mm:ss) — The holdtime of a Candidate-RP. If the local router is not the BSR, this
value is 0.
• Expiry Time (hh:mm:ss) — The minimum time remaining before the Candidate-RP is declared down.
•
Component — A number which uniquely identifies the component. Each protocol instance
connected to a separate domain should have a different index value.
Displaying RP Set Summary using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM-SM Commands