Dell POWEREDGE M1000E - Manual (Page 627)

Configuring Quality of Service 625
– All — All the various match criteria defined for the class should be satisfied for a packet match. All
signifies the logical AND of all the match criteria.
• Protocol — Indicates how to interpret Layer 3. This field displays the types of packets supported by
DiffServ. The Layer 3 Protocol option is available only when you select Class Type. Options are:
–
IPv4 — A class where the match criteria is based on fields in an IPv4 packet.
– IPv6 — A class where the match criteria is based on fields in an IPv6 packet.
The protocol is chosen on the Add DiffServ Class page. See "Adding a DiffServ Class" on page 625.
• Remove — Deletes the displayed class name when checked and Apply Changes is clicked.
Adding a DiffServ Class
1. Open the Diffserv Class Configuration page.
2. Click Add.
The Add DiffServ Class page displays
Figure 11-3. Add DiffServ Class
Enter a name for the class and select the protocol to use for class match criteria.
3. Click Apply Changes.
The new class is added and the device is updated.
Adding a Class Configuration Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands